Dell Optiplex SFF All-in-One Stand information (FDXW3)
I had a client interested in the Dell Optiplex 7010 Small Form Factor All-in-One stand, but I had a tough time finding out any information about it. I bought two and here’s what I’ve learned:
- The new one I just bought in 12/2012 is 73DH9 (073DH9) and it may be the same as FDXW3 (0FDXw3)
- I know this one is made for the Optiplex 7010, but I read that it should work with 990, 790, 390 (SFF only, of course).
- Here’s a very good source of pictures or here is Red Planet Trading’s cache of photos.
- It will only work with Dell monitors with their special “clip-in” system, such as the 1908FP or P190S.
- This stand will handle up to 13.2 lbs (6 kg).
Here is a better picture showing the monitor mount:
And here is what it looks like if you remove that metal piece and put it against a 10 CM x 10 CM VESA mount screw holes:
Here are the fancy instructions (click to enlarge):
Brian,
Thanks for your write-up on this. So there is no way just to ditch that metal thing and plug right into the black bracket on the stand? It looks like those holes might line-up?….
If I remember right, there just isn’t a way to use a regular VESA-holed monitor. I was just looking at some of the other pictures I linked to and even if there were holes, I don’t think you could get a screwdriver behind to install screws anyway.
Brian, any idea where I can find a dell all in one stand for a 780 sff?
I just searched on eBay for “dell 780 all-in-one stand”, however they all appear to refer to a stand for the USFF.
Here is a picture:
http://www.designdirectory.com/firm/project?firm_id=264638&project_id=2470
I’m guessing this means that the 780 SFF doesn’t have an all-in-one stand available.